|
Post by guildx700 on May 14, 2020 22:35:24 GMT -5
Yup, cheap retro look amp, but I love this little thing. Done some mods to it over time. I salvaged a larger speaker from my Bugera tube amp upgrade & made a 3/4" thick plywood front baffle board. New grill cloth too. It sounds pretty good for what it is cranks loud for only 15 watts solid state with nice breakup and sustain. Fairly well made considering low cost, it has a real amplifier circuit not some cheap op amps IC's. It has some transistors mounted to a decent heat sink and a good size power transformer. I braced the bottom of the new baffle good to handle the extra bottom end the bigger speaker put out. Also replaced the short 18 gauge power cord with a longer 14 gauge OFC one so I don't need to use an extension cord. It has 2 channels, clean and overdrive along with analog reverb and delay, which IMHO sounds much better than most digital reverb, it's fairly lush. I'm really digging this little thing for a solid state, cheap amp. Upgraded, larger speaker:
|
|
|
Post by LTB on May 16, 2020 5:01:21 GMT -5
Always liked the look of Custom Amps back in the day. Cool you were able to fit that speaker into that amp with another speaker board. I’ll bet the difference in sound is noticeably better
|
|
|
Post by guildx700 on May 16, 2020 22:41:37 GMT -5
Always liked the look of Custom Amps back in the day. Cool you were able to fit that speaker into that amp with another speaker board. I’ll bet the difference in sound is noticeably better It turned it into a real, usable amp. The little thing is fun as hell to use now. It makes good use of the amp's 15 watts, and the stiffer 3/4" plywood front baffle keeps things from rattling, the stock baffle was only 1/2" particle board, very flimsy. That stock speaker simply did not have enough effective piston area to move much air. That bigger one really woke it up. It was a tight fit, but I took my time and did it right with plenty of wood cleats to mount the front to the box solidly all the way around.
|
|
|
Post by LTB on May 16, 2020 23:00:06 GMT -5
guildx700, the larger speaker must be close to the ends of the front speaker board I assume, correct? Doesn't matter just curious that's all
|
|
|
Post by guildx700 on May 16, 2020 23:55:47 GMT -5
guildx700, the larger speaker must be close to the ends of the front speaker board I assume, correct? Doesn't matter just curious that's all There is enough "meat" on the front baffle at all the sides of the speaker cutout. That was a concern of mine going into it until I got it all fitted. They really should've just fitted that 8" size from the factory. Huge improvement.
|
|
|
Post by LTB on May 18, 2020 23:38:10 GMT -5
] They really should've just fitted that 8" size from the factory. Huge improvement. What size was the original then? I was thinking the smaller speaker was 8” And larger 10”or 12”
|
|
|
Post by guildx700 on May 19, 2020 20:30:15 GMT -5
"What size was the original then? I was thinking the smaller speaker was 8”.....And larger 10”or 12”.
Original was only about a 6"and VERY shallow.
That replacement is an 8", but it's also fairly deep giving it a decent effective piston area, it can move the air pretty good now!
|
|