|
Post by Jim D. on Jan 8, 2022 9:59:41 GMT -5
Assuming my basic knowledge is correct, I understand capacitors are best not left unpowered for extended periods of time. The term I have heard is reforming capacitors after they have been idle. I have several good all tube amps. Some are not used often. How often should I power up a seldom used tube amp, and what is the preferred procedure? This is to say I do not know if the standby switch should come into play here.
|
|
|
Post by Leftee on Jan 8, 2022 10:26:35 GMT -5
Once a year is plenty. No standby switch is required - and I don’t advise using those any more. Just make sure a speaker/load is hooked up, turn gain/volumes all the way down and power the amp up. Letting it sit like that for a couple/three minutes is fine.
|
|
|
Post by Jim D. on Jan 8, 2022 10:34:09 GMT -5
Thank you Leftee.
|
|
|
Post by reverendrob on Jan 8, 2022 17:05:02 GMT -5
I just keep them connected to power - that's been enough in my experience for seldom-used amps.
Haven't had one go south yet.
|
|
DrKev
Wholenote
It's just a guitar, it's not rocket science.
Posts: 424
|
Post by DrKev on Jan 18, 2022 10:32:33 GMT -5
I just keep them connected to power - that's been enough in my experience for seldom-used amps. Haven't had one go south yet. But if the on-switch is not switched on, the amp is NOT connected to power, only one side of the switch is.
|
|
pdf64
Wholenote
Posts: 558
|
Post by pdf64 on Jan 18, 2022 13:09:09 GMT -5
|
|