Post by Larry Madsen on Jan 13, 2021 13:32:10 GMT -5
I mentioned on the other strap thread that I was getting a bit itchy to make a couple of new straps.
These literally are some mis-match scraps I have sitting in a bin. Probably should have taken a PIC with piled up on the table before I started.
DSC_2458 by Larry Madsen, on Flickr
The pieces I have here will be the front tip liner going on the back side. Two scraps have already been laminated to create the front of the strap.
Here it is together and cut to a decent front tip shape. Ignore the dark spots, it's solvent moisture I used to eliminate some crud on the leather.
DSC_2460 by Larry Madsen, on Flickr
This is another more or less complete strap project I cut quite a while back. These pieces were in the box with the scraps.
I walked away from this one because I couldn't make up my mind on the path forward at the time. I'm not sure I know the path forward on it even now. Maybe I'll think of something as I mess around here.
It's a single piece face with re-enforcement end laminate pieces and then a black pigskin liner.
DSC_2459 by Larry Madsen, on Flickr
This 24 hours to edit is great!
Here is the above strap now. I had mentioned in the other thread that I had a "polka-dot" strap that had went to another user in the past and I had wanted to replace it. Well, here it begins.
DSC_2462 by Larry Madsen, on Flickr
These literally are some mis-match scraps I have sitting in a bin. Probably should have taken a PIC with piled up on the table before I started.
DSC_2458 by Larry Madsen, on FlickrThe pieces I have here will be the front tip liner going on the back side. Two scraps have already been laminated to create the front of the strap.
Here it is together and cut to a decent front tip shape. Ignore the dark spots, it's solvent moisture I used to eliminate some crud on the leather.
DSC_2460 by Larry Madsen, on FlickrThis is another more or less complete strap project I cut quite a while back. These pieces were in the box with the scraps.
I walked away from this one because I couldn't make up my mind on the path forward at the time. I'm not sure I know the path forward on it even now. Maybe I'll think of something as I mess around here.
It's a single piece face with re-enforcement end laminate pieces and then a black pigskin liner.
DSC_2459 by Larry Madsen, on FlickrThis 24 hours to edit is great!
Here is the above strap now. I had mentioned in the other thread that I had a "polka-dot" strap that had went to another user in the past and I had wanted to replace it. Well, here it begins.
DSC_2462 by Larry Madsen, on Flickr
